¾ 7-1-18 ¾
Caller-ID Table
2. To store a Displayed Caller-ID information to Caller-ID Table
at the no ringing extension
.
Display Indication Operation and Information
##SUN# 25# 12:00PM
10##############
(On-Hook condition)
1. To answer incoming call or line on hold.
0448111111######
NITSUKO# CORP.###
2. Press FLASH key.
3. Press Line key or DLS (TX-Z 1232/2464)key.
* If a caller's number information is not available, the
message (NO NUMBER INFO) will be shown at upper
column of Display.
* The information is recommended to be entered in the
combination of Number and Name.
4. Press OPAC key.
5. Dial 90.
* An indicated information will be stored to empty Memory
area in Caller-ID table.
* When the information has been stored to Caller-ID table,
confirmation tone shall be heard. However, if the system
is following conditions, error tone shall be heard.
(1) KTS is not allowed to edit. (#61-C)
(2) Caller's telephone number information is not available.
(3) Other KTS is storing some information simultaneously.
(4) Caller-ID table is fully occupied.
Note:
If you assigned to DISABLE (at #15-E), the above operation No. 2 is not required.
To Next Page
Loading...