¾ 7-3-3-21 ¾
Features on Transfer
To confirm a Transfer Message (Personal Message):
Display Indication Operation and Information
##SUN# 25# 12:00PM
PLY.TRFR.MESSAGE
(KTS)
1. Lift handset or press SPK. (See Note 1)
2. Dial 951. (Playing start.) (see Note 2, 3)
3. Hear a message from handset or built-in speaker.
(see Note 4)
##SUN# 25# 12:00PM
10##############
4. Hang up or press SPK.
(SLT)
1. Lift handset.
2. Dial 7 and 951. (Dial Plan 1) (see Note 2, 3)
or
2. Dial 0571 (9571). (Dial Plan 2) (see Note 2, 3)
3. Hear a message from handset. (see Note 4)
4. Hang up.
Note 1: When Program #75-D is 0 (No tone), press ICM key
to seize Intercom after lifting handset.
Note 2: When VAU unit is not inserted in the system or Voice
Paths are occupied, Busy Tone will be sent.
Note 3: When Personal Message is not recorded, Dial Tone
may be sent.
Note 4: When recorded contents has been finished, 1-beep
tone (400 Hz, 0.5 sec.) will be sent.
To record a Paging Message (Personal Message):
(This operation requires that extension is set the
Meet-Me Paging Transfer Mode
and recorded a
Meet-Me Paging Transfer Message
.)
Display Indication Operation and Information
##SUN# 25# 12:00PM
REC.PAGE# MESSAGE
(KTS)
1. Lift handset or press SPK. (See Note 1)
2. Dial 952. (see Note 2)
00:00:00# 12:00PM
REC.PAGE# MESSAGE
3. Dial
*
. (Recording and timer counting start.)
4. Record a message from handset or MIC.
00:00:06# 12:00PM
REC.PAGE# MESSAGE
5. Dial
*
. (Recording and timer counting finish.)
(For Example: Recording time is 6 sec.)
(see Note 3)
To Next Page
Loading...