5
Troubleshooting
5-60 CS193/CS173/CS163
If any message other than those listed above appears, perform the operation described in the message.
If the problem is not corrected after the described operation is performed, contact your service
representative.
Finish-
er
The finisher cannot be used. Is no power supplied to the con-
nector?
Check that the cord is correctly in-
serted into the connector.
The pages cannot be stapled. Have the staples run out? Replace the staple cartridge. (See
p. 9-17.)
The staple is incorrectly posi-
tioned by 90 degrees.
Is the staple position correctly
specified?
Specify the desired position for
stapling. (See p. 3-72.)
The pages that were fed out
were not uniformly loaded
and the punched holes or sta-
ples are incorrectly posi-
tioned.
Is the paper curled? Remove the paper from the paper
tray, turn it over, and then load it
again.
Is there a gap between the lateral
guides in the paper tray and the
sides of the paper?
Slide the lateral guides in the paper
tray against the sides of the paper
so that there is no gap.
Even though a Punch setting
was selected, holes are not
punched. (when the punch kit
is installed on the finisher)
Did the message "Empty punch
scraps box." appear?
Empty the punch scrap box. (See
p. 9-22)
Symptom Possible cause Remedy
To Next Page
Loading...
