CS193/CS173/CS163 12-27
Utility mode
12
Reset Settings
2
Reminder
Even if the System Auto Reset Time is [OFF], the System Auto Reset function is activated after 1 minute
of no operation of the machine during the User Authentication or Account Track.However, when in the
Enlarge Display mode, the System Auto Reset function is not activated.
If user authentication settings have been specified or "Enhanced Security Mode" has been set to "ON",
the logoff from Administrator mode or user authentication mode will be performed according to the
"System Auto Reset Time" parameter.
Parameter Description Default Setting
System Auto Reset Specify the desired length of time until the auto-
matic system reset operation is performed.
•Priority Mode:
Select the setting ("Copy" or "Scan/Fax") for
the mode that the machine enters when the
automatic system reset operation is per-
formed.
• System Auto Reset Time:
Specify the setting (between 1 and 9 minutes
or "OFF") for the desired length of time until
the automatic system reset operation is per-
formed.
Priority Mode:
Copy
System Auto Reset
Time: 1 Minute
Auto Reset Select the setting (between 1 and 9 minutes or
"OFF") for the desired length of time until the au-
tomatic panel reset operation is performed for
each mode (Copy and Scan/Fax).
Copy: 1 Minute
Scan/Fax: 1 Minute
Job Reset When Account is
changed
Select whether or not the settings are reset (initial-
ized) when the user has changed.
This machine detects that the user has changed
when the optional key counter has been removed
or when the user has logged off if user authentica-
tion or account track settings are specified.
Reset
When original
is set on ADF
Select whether or not the settings are reset when
an original is loaded into the automatic document
feeder.
Do Not Reset
Next Job Staple Setting:
Select whether the same Staple setting from the
previous job is set or the setting is canceled when
that job begins and the settings for the next job
can be specified.
OFF
Original Set/Bind Direction:
Select whether the same Original Direction and
Binding Position settings from the previous job
are set or the settings are canceled when that job
begins and the settings for the next job can be
specified.
OFF
Reset Data After Job:
Select whether the same settings for a scan oper-
ation or for a fax transmission from the previous
job are set or the settings are canceled when that
job is completed and the settings for the next job
can be specified. (However, even if "OFF" is se-
lected, the destination is cleared.)
ON
To Next Page
Loading...
