CS193/CS173/CS163 12-31
Utility mode
12
Limiting Access to Destinations
Authentication Device Settings
!
Detail
The Authentication Device Settings parameters are available only if the optional authentication unit is
installed.
The authentication units of the IC card type and the biometric type cannot be installed at the same time.
Using Touch & Print, a user can print a job sent from a computer by positioning their finger or IC card
on the authentication unit
Parameter Description
Create Group Groups for permitting access to destinations can be registered and edited.
Apply Levels/Groups to Destina-
tions
The access permission level and the group with access permissions can be
specified for each destination.
Apply Levels/Groups to Users The access permission level and the group with access permissions can be
specified for each user.
Parameter Description Default setting
General Settings Specify the settings for the installed authentication unit.
• Card Authentication: Select the IC card type and op-
eration settings.
• Bio Authentication: Select the beep and operation
settings.
When the authentication
unit (IC card type) has
been installed:
IC Card Type: FeliCa
Operation Settings: Card
Authentication
When the authentication
unit (biometric type) has
been installed:
Beep Sound: ON
Operation Settings: 1-to-
many authentication
Touch & Print Setting Select the printing operation for Touch & Print.
• ON: Select this setting to select whether all jobs or
only one job is printed.
• OFF: Select this setting to prevent printing with
Touch & Print.
ON: Print All Jobs
Logoff Settings Select whether or not the user is logged off after a scan
or fax is sent or after the copy original is scanned.
Do not log off
To Next Page
Loading...
