15 February 2006 2000/3000 SHEET FINISHERS (B700/B701)
1-85
Installation
Shift Auxiliary Tray
1. Open and close the front door of the finisher.
This initializes the finisher and moves the shift tray to the standby position.
2. Open the front door again and leave it
open.
3. Set the shift auxiliary tray [A] on the
shift tray as shown.
4. Close the front door.
This initializes the finisher again and
moves the shift tray to the new standby
position with the auxiliary tray installed.
5. After the Z-folding job is finished,
remove the tray and store it in the
auxiliary tray storage pocket on the
back of the finisher.
6. Open and close the front door to re-
initialize the finisher and reset the
standby position of the shift tray.
B246I902.WMF
[A]
To Next Page
Loading...
Need help?
General
