15 February 2006 MAIN MACHINE (B064 SERIES/B140 SERIES/B246 SERIES)
1-15
Installation
Removing and Filling the Development Unit
Important!
• Before you begin, remove the toner bottle
if it is installed.
• The toner bottle holder can be damaged if
it is in the machine when you do the
procedure below.
1. Remove the shutter cover [A] (" x 1).
2. Remove the lock screw [B].
3. Remove any remaining shipping tape
[C].
4. Pull the toner bottle holder [D] and
swing it to the right.
5. Remove the face plate [E] of the
development unit (knob x 1, " x 2).
6. Disconnect the development unit [F]
(# x 2).
NOTE: If the LCT is installed, disconnect
it. This lets the front door open far
enough for development unit removal.
7. Close the supply pipe shutter [G].
8. While allowing the development unit [H]
to slip to the right, slowly pull it out of the
machine.
B064I300.WMF
B064I302.WMF
B064I303.WMF
[G]
[H]
[F]
[E]
[A]
[B]
[C]
[D]
To Next Page
Loading...
