MFP OPTIONS: B064 SERIES 15 February 2006
1-144
UP Mode Settings for IEEE 1394
Enter the UP mode and follow the procedure below to perform the initial interface
settings for IEEE 1394. These settings take effect every time the machine is
powered on.
1. Press User Tools/Counter.
2. On the touch panel, press System Settings.
3. Press Interface Settings.
4. Press the key and enter the following settings:
• IP Address
• Subnet Mask
• IP Over 1394. Enable or disable this setting as required. This setting enables
IP Over 1394 as the default setting for the printing method.
• SCSI Print. Enable or disable this setting as required. This setting enables
SCSI Print as the default setting for the printing method.
• SCSI Print Bi-directional. Switch bi-directional printing on or off for SCSI print.
Network Parallel Interface
IEEE 1394 IEEE 802.1b
IP Address
Subnet Mask
IP Over 1394
SCSI Print
0000.0000.0000.0000
0000.0000.0000.0000
Enabled
Enabled
SCSI Print Bi-directional
On
Select the desired settings.
System Intialization Settings End
B064I998.WMF
To Next Page
Loading...
Need help?
General
