INSTALLATION REQUIREMENTS 15 February 2006
1-2
7. Do not place the machine where it will be exposed to corrosive gases.
8. Do not install the machine at any location over 2,000 m (6,500 feet) above sea
level.
9. Place the copier on a strong and level base with the front and back of the
machine within ±5 mm (0.2") of level.
10. Do not place the machine where it may be subjected to strong vibrations.
11. Do not connect the machine to a power source shared with another electrical
appliance.
12. The machine can generate a an electromagnetic field which could interfere with
radio or television reception.
1.1.2 MACHINE LEVEL
1. Front to back:
Within ±5 mm (0.2") of level
2. Right to left:
Within ±5 mm (0.2") of level
The machine legs may be screwed up or down in order to level the machine. Set a
carpenter’s level on the exposure glass.
To Next Page
Loading...
