COPY CONNECTOR KITS 15 February 2006
1-118
1.21 COPY CONNECTOR KITS
1.21.1 COPY CONNECTOR KIT (B525-10, -12) FOR B064 SERIES
Important Notes
1. The following are the specialized firmware versions for use with the Copy
Connector Kit or MLB option. When installing either of these options, it is
necessary to install the following firmware together as a set.
Software Part Number Version (1st released)
GW Controller: System B5254108 5.07
GW Controller: Copy B5254109 5.07
BCU B5254123 5.03d
Printer/Scanner B5255204 4.15/5.00
NIB/Netfile B5254114 3.00/1.79
B5254176 (NA)
LCDC
B5254177 (EU)
2.04
2. With the Copy Connector/MLB modifications, the machine firmware has been
divided up into 2 main groups:
1) The Copy Connector/MLB group (beginning with the versions listed above)
2) The usual firmware used up to the present, i.e. for machines without the
Copy Connector or MLB options.
Important: Firmware from these two groups cannot be used interchangeably.
Always update within the same group, otherwise the machine will not operate
correctly.
3. The Copy Connector Kit and MLB options cannot be installed in the same
machine. It is necessary to install one or the other.
4. As shown above, the GW controller firmware for the Copy Connector/MLB
group has been divided into GW System and GW Copy, as the increased size
has exceeded the card's storage capacity.
To Next Page
Loading...
Need help?
General
