15 February 2006 Z-FOLDING UNIT (B660)
1-67
Installation
1.13.2 INSTALLATION PROCEDURE
Important!
• The Z-Folding Unit B660 can be installed and used only on the Finisher B674,
B700, or B701.
Before You Begin
• Do the installation procedure for the finisher but do not dock it to the machine.
The Z-folding unit must be installed between the finisher and the main machine.
• Do the installation for the cover interposer tray (if necessary).
• If the finisher is already installed, disconnect the finisher from the main machine.
(If the cover interposer tray is installed on the finisher, it is not necessary to
remove the cover interposer tray.)
To Next Page
Loading...
