COPY CONNECTOR KITS 15 February 2006
1-128
5. Connect one end [A] of the power supply harness to the mother board (# x 1).
6. Connect the other end [B] of the power supply harness to the connector board
(# x 1).
7. Connect the 64 MB DIMM [C] to the mother board.
NOTE: This memory chip is a data transfer buffer.
8. Connect the connector board [D] to Slot A2.
9. Connect one end of the connector cable [E] to the copy connector board.
10. Connect the other end of the cable to the other machine.
-or-
If the distance between the machines is more than 4.5 m (14.8 ft.), connect the
cables to a connector hub [F].
B661I113.WMF
B659I112.WMF
[A]
[B]
[C]
[D]
[E]
[F]
To Next Page
Loading...
