Ricoh MT-C1 User Manual

B064 SERIES SERVICE MODE 15 February 2006
4-36
SC No. Symptom Possible Cause
IEEE802 11b card startup error 853 D
Not used.
IEEE802 11b card access error 854 D
Not used.
IEEE802 11b card error 855 D
Not used.
IEEE802 11b card connection board error 856 D
Not used.
Address book data error 870 B
The address book in the hard disk is
accessed. → An error is detected in
the address book data; address book
data is not read; or data is not written
into the address book.
NOTE: To recover from the error, do
any of the following
countermeasures:
Format the address book by using
SP5-832-008 (all data in the address
book–including the user codes and
counters–is initialized)
Initialize the user data by using SP5-
832-006 and -007 (the user codes
and counters are recovered when the
main switch is turned on).
Replace the hard disk (the user
codes and counters are recovered
when the main switch is turned on).
• Data corruption
• Defective hard disk
• Defective software
Printer error 920 D
The printer program cannot be
continued.
• Defective hardware
• Data corruption
• Defective software
Net file error 925 D
The management file for net files is
corrupted; net files are not normally
read.
Netfiles: Jobs to be printed from the
document server using a PC and the
DeskTopBinder software
• Defective hardware
• Data corruption
• Defective software
Other system SCs 992 C
The controller received an unknown
SC code from the engine.
• Contact your product specialist.
Network error 993 D
The ASIC program of GW controller
cannot be continued.
• Defective ASIC
• Defective GW controller

Ricoh MT-C1 Specifications

General

Brand	Ricoh
Model	MT-C1
Category	All in One Printer
Language	English