15 February 2006 OTHER PROBLEMS (B064/B140/B246 SERIES)
4-85
Trouble-
shooting
Symptom 3: Other
1. If none of the two symptoms 1 or 2 applies, do this procedure.
2. Use SP7504 to check the jam counts and find which SPs have high counts.
3. From the table and illustration below, find which gears must be replaced.
Example: For tray 1, if SP7504-012 is high, replace gear A, or if SP7504-008 is
high, replace gear B.
Tray SP7504 12 SP7504 8 SP7504 9 SP7504 10 SP7504 11
Tray 1 Gear [A] Gear [B]
Tray 2 Gear [A] Gear [B]
Tray 3 Gear [A] Gear [B]
Tray 4 Gear [A] Gear [B]
4. Clean the shafts and replace the necessary gears.
5. Replace a gear if its cutout and arrow are not in the same position.
6. When you replace Gear [A] or Gear [B], be sure to put the metal face on the
outer side, and the arrow must be in view.
7. If a replacement gear is not available, do this as a temporary procedure:
1) Remove the paper feed unit.
2) Remove the gear.
3) Clean the gear shaft and inside the gear.
4) Attach the gear.
5) Install the paper feed unit.
B246T906.WMF
[A]
[B]
To Next Page
Loading...
Need help?
General
