Ricoh MT-C1 - Page 520

15 February 2006 SERVICE PROGRAM MODE TABLES
5-47
Service
Tables
2934* Transfer Current On/Off Timing (Tray 3)
001 La1 Adjusts on transfer current ON timing for front side copying.
[–30~+30/1 mm]
002 La1f Adjusts the area where transfer current is applied for the
leading edge during front side copying.
[0~+20/1 mm]
003 Lc1r Adjusts the area where transfer current is applied for the
trailing edge during front side copying.
[0~+20/1 mm]
004 Lc1 Adjusts the transfer current OFF timing for front side
copying.
[–30~+30/1 mm]
005 La2 Adjusts on transfer current ON timing for back side copying.
[–30~+30/1 mm]
006 La2f DFU Adjusts the area where transfer current is applied for the
leading edge during rear side copying.
[0~+20/1 mm]
007 Lc2r Adjusts the area where transfer current is applied for the
trailing edge during back side copying.
[0~+20/1 mm]
008 Lc2 Adjusts the transfer current OFF timing for back side
copying.
[–30~+30/1 mm]
009 La3 Adjusts the transfer current ON timing for copying thick
paper from Tray 3.
[–30~+30/1 mm]
010 La3f Adjusts the transfer current OFF timing for the leading edge
length when copying thick paper from Tray 3.
[0~20/1 mm]
011 Lc3r Adjusts the transfer current ON timing for the trailing edge
length when copying with thick paper from Tray 3.
[0~20/1 mm]
012 Lc3 Adjusts the transfer current OFF timing for copying with
thick paper from Tray 3.
[–30~+30/1 mm]