Ricoh MT-C1 - Page 522

15 February 2006 SERVICE PROGRAM MODE TABLES
5-49
Service
Tables
2936 Transfer Current On/Off Timing (By-pass)
001 La1 Adjusts on transfer current ON timing for front side copying.
[–30~+30/1 mm]
002 La1f Adjusts the area where transfer current is applied for the
leading edge during front side copying.
[0~+20/1 mm]
003 Lc1r Adjusts the area where transfer current is applied for the
trailing edge during front side copying.
[0~+20/1 mm]
004 Lc1 Adjusts the transfer current OFF timing for front side copying.
[–30~+30/1 mm]
009 La3 Adjusts the transfer current ON timing for copying on thick
paper.
[–30~+30/1 mm]
010 La3f Adjusts the transfer current OFF timing for the leading edge
length when copying on thick paper.
[0~20/1 mm]
011 Lc3r Adjusts the transfer current ON timing for the trailing edge
length when copying with thick paper.
[0~20/1 mm]
012 Lc3 Adjusts the transfer current OFF timing for the leading edge
when copying with thick paper.
[–30~+30/1 mm]
013 La4 Adjusts the transfer current OFF timing for copying with
OHP.
[–30~+30/1 mm]
014 La4f Adjusts the transfer current OFF timing for the leading edge
when copying with OHP.
[0~20/1 mm]
015 Lc4r Adjusts the transfer current OFF timing for the trailing edge
when copying with OHP.
[0~20/1 mm]
016 Lc4 Adjusts the transfer current OFF timing for copying with
OHP.
[0~20/1 mm]