15 February 2006 SERVICE PROGRAM MODE TABLES
5-73
Service
Tables
5227 Page Numbering (B246)
200 Change Page No. Display
This SP code determines whether the page number adjustment display is on or off.
[0~1/0/1]
0: Display off
1: Display on
201 Allow Page No. Entry
This SP specifies the number of digits to display for the entry of the starting page
number.
[2~9/9/1]
202 Zero Surplus Setting
This setting determines whether page numbers are prefixed with excess zeros
when the number is smaller than the number of assigned digits. For example, with
this setting on and 3 digits have been specified, the number "3" appears as "003".
With this setting off, the number "3" will appear as a "3" without the zeros.
[0~1/0/1]
0: No excess zeros
1: Excess zeros displayed
5212* Page Numbering
003 Duplex Printout Left/Right Position Horizontally positions the page numbers
printed on both sides during duplexing.
[–10~+10/1 mm]
0 is center, minus is left, + is right.
004 Duplex Printout High/Low Position Vertically positions the page numbers
printed on both sides during duplexing.
[–10~+10/1 mm]
0 is center, minus is down, + is up.
5302 Set Time DFU
Sets the time clock for the local time. This setting is done at the factory before
delivery. The setting is GMT expressed in minutes.
[–1440~1440/1 min.]
JA: +540 (Tokyo)
NA: -300 (NY)
EU: +6- (Paris)
CH: +480 (Peking)
TW: +480 (Taipei)
AS: +480 (Hong Kong)
Auto Off Function Release Setting 5305
This SP prevents the user from easily disabling the auto off timer. This is done to
conform with international Energy Star standards that specifically state that the
user shall not be able to easily switch off the auto off feature.
0: On (Auto Off cannot be released
1: Off (Auto Off can be released)
To Next Page
Loading...
Need help?
General
