Ricoh MT-C1 - Page 560

15 February 2006 SERVICE PROGRAM MODE TABLES
5-87
Service
Tables
156 Dial Up User Name
Use this SP to set a user name for access to remote dial up. Follow these rules
when setting a user name:
• Name length: Up to 32 characters
• Spaces and # allowed but the entire entry must be enclosed by double
quotation marks (").
157 Dial Up Password
Use this SP to set a password for access to remote dial up. Follow these rules
when setting a user name:
• Name length: Up to 32 characters
• Spaces and # allowed but the entire entry must be enclosed by double
quotation marks (").
159 Remote Service: Carrier Send Level
This SP sets the level of the carrier signal for Cumin-M data transmissions.
[0~15/3/1]
160 Remote Service: AT command
This SP allows you to add an AT command to the initialization of the Cumin-M
modem. This SP sets the AT command for both initialization and wait time of
and outgoing call. It also includes the NULL instruction.
Default: 0, up to 8 characters allowed.
161 Local Phone Number
Use this SP to set the telephone number of the line where Cumin-M is
connected. This number is transmitted to and used by the Call Center to return
calls.
Limit: 24 numbers (numbers)
162 Connection Timing Adjustment: Incoming
When the Call Center calls out to a Cumin-M modem, it sends a repeating ID
tone (*#1#). This SP sets the line remains open to send these ID tones after the
number of the Cumin-M modem is dialed up and connected.
[0~24/1/1]
The actual amount of time is this setting x 2 sec. For example, if you set "2" the
line will remain open for 4 sec.
163 Access Point
This is the number of the dial-up access point for Cumin-M. If no setting is done
for this SP code, then a preset value (determined by the country selected) is
used.
Default: 0
Allowed: Up to 16 alphanumeric characters
164 Line Connecting
This SP sets the connection conditions for the customer. This setting dedicates
the line to Cumin-M only, or sets the line for sharing between Cumin-M and a
fax unit.
[0~1/0/1]
0: Line shared by Cumin-M/Fax
1: Line dedicated to Cumin-M only
Note:
• If this setting is changed, the copier must be cycled off and on.
• SP5816 187 determines whether the off-hook button can be used to interrupt
a Cumin-M transmission in progress to open the line for fax transaction.