Ricoh MT-C1 - Page 651

SERVICE PROGRAM MODE TABLES 15 February 2006
5-178
Text Mode
001* MTF Filter Coefficient
(Text/Binary/Main scan)
Selects the MTF filter coefficient in the main
scan direction for Text mode.
Select a higher number for a stronger filter.
If this is “0”, the MTF filter is not applied.
[0~15/1]
002* MTF Filter Coefficient
(Text/Binary/Sub scan)
As above, for sub scan
[0~13/1]
003* MTF Filter Strength
(Text/Binary/Main scan)
Selects the MTF filter strength in the main
scan direction for Text mode.
Select a higher number for a stronger filter.
[0~7/1]
004* MTF Filter Strength
(Text/Binary/Sub scan)
As above, for sub scan
[0~7/1]
005* Smoothing Filter
(Text/Binary)
Selects the smoothing pattern for Text mode
when using binary picture processing mode.
A larger value could cause moiré to appear in
the image.
[0~7/1]
006* Scanner Gamma
(Text/Binary)
Selects the scanner gamma type for Text
mode when using binary picture processing
mode.
[0~6/1]
007* Brightness – Notch 7
(Text/Binary)
The following SPs adjust the image density
(brightness, contrast, and thresholds) for each
image density level (from 7 to 1) for Text
mode when using binary picture processing
mode. The settings are reflected in the
gamma table.
[0~255/1]
008* Contrast – Notch 7
(Text/Binary)
[0~255/1]
009* Threshold Level – Notch 7
(Text/Binary)
[0~255/1]
010* Brightness – Notch 6
(Text/Binary)
[0~255/1]
011* Contrast – Notch 6
(Text/Binary)
[0~255/1]
012* Threshold Level – Notch 6
(Text/Binary)
[0~255/1]
013* Brightness – Notch 5
(Text/Binary)
[0~255/1]
014 Density Level 5:
Contrast
[1~255/1]
015 Density Level 5:
Threshold
[1~255/1]
016 Density Level 4:
Intermediate Brightness
[1~255/1]
2002
017 Density Level 4:
Intermediate Contrast
[1~255/1]