15 February 2006 ADF
6-19
Detailed
Descriptions
Here is a summary of the skew correction methods.
➀ Skew correction sensor/entrance roller
B6, A5, HLT Larger Than A5
Duplex Scanning Yes Yes
Simplex Scanning Yes Yes
NOTE: Skew is always corrected with method # for every job, regardless of the
paper size and mode.
➁ Interval sensor/pre-scanning roller stop correction
B6, A5, HLT Larger Than A5
Duplex Scanning Yes Yes
Simplex Scanning Yes No
NOTE: Use SP6020 (ADF Contact Mode In/Out) to enable skew correction method
➁ for all jobs to ensure accurate original feeding. However, switching this
feature on slows original feed slightly.
➂ Interval sensor/pre-scanning roller slow-down correction
B6, A5, HLT Larger Than A5
Duplex Scanning No No
Simplex Scanning No Yes
To Next Page
Loading...
