ADF 15 February 2006
6-22
Changing the Default Selection with SP6016 and SP5126
Here is a list of paper sizes that can be set for the default to enable detection. The
bold sizes are the default settings, and the italic sizes are the alternate settings.
North America Europe/Asia
64 DL SEF 11" x 15" 4 8 K DL SEF
32 LT LEF Exec LEF 2 16 K SEF LT SEF
16 LT SEF 8" x 10" SEF 1 16 K LEF LT LEF
8 LG SEF Set by SP 5126
To change the default settings:
1. Enter the SP mode.
2. Select SP6016.
3. Replace the default settings with the alternate settings.
• In North America, enter 120 to replace the default settings with the alternate
settings. The bold settings in the table above are replaced with the italicized
settings.
• In Europe (or Asia), enter 7 to replace the default settings with the alternate
settings. The bold settings in the table above are replaced with the italicized
settings.
4. To restore all the default settings in either North America or Europe/Asia, enter
“0”.
SP 5126
This SP controls the alternative paper sizes that are detected for LG SEF (USA) or
8 ½ x 13" (Europe/Asia).
To Next Page
Loading...
