SATO CT4-LX - Page 138

Setting Batch Print Settings in Media Startup (When Using Only One Type of Media)
138
7.
Tap the type of sensor to use, and then tap or slide the screen to the left.
• If you have selected [Wristband] for media type, you can only select [Gap] or [I-Mark].
• If you have selected [koDakara] for media type, you can only select [I-Mark].
• Select something other than [None] to use the Label Waste Prevention function.
• Select something other than [None] to use RFID tags on an RFID model. If you set
[None], you cannot use RFID tags.
8. Tap [Start] and execute automatic sensor adjustment according to the on-screen
instructions.
Remove the label from the liner and set the liner so the I-mark is not above the I-mark sensor.
For media without liners, such as wristbands or journal paper, load the media as is.
When the sensor adjustment is complete, the [Sensor adjustment] value changes to [Complete].