139
• This is displayed only if you have selected [Gap] or [I-Mark] for the sensor type.
• The results of executing automatic sensor calibration are reflected in the setting items
under [Printing] > [Advanced] > [Calibrate].
9.
Tap or slide the screen to the left.
10. Select whether to enable or disable the Label Waste Prevention function, and then
tap or slide the screen to the left.
• This is not displayed if the optional dispenser unit or linerless cutter unit is installed.
• When using linerless labels, journal paper, or RFID tags, you cannot use the Label
Waste Prevention function.
11. Tap [Edit].
To Next Page
Loading...
