Setting Batch Print Settings in Media Startup (When Using Only One Type of Media)
140
To accurately execute the Label Waste Prevention function, register the length of the media.
Register the range of the label length (including liner) that the following illustration shows.
(1) Label length (including liner)
(2) Label
(3) Liner
Calculate the values from the following equations to input dots.
◦ 203 dpi: Label length (mm) x 8
◦ 305 dpi: Label length (mm) x 12
• This is not displayed if the optional dispenser unit or linerless cutter unit is installed.
• This is displayed if you have selected [Label] for the media type, and selected [Gap] or
[I-Mark] for the sensor type, and enabled the Label Waste Prevention function.
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
12.
Tap or slide the screen to the left.
To Next Page
Loading...
