SATO CT4-LX - Page 145

145
7. For the combined direct thermal/thermal transfer model, tap the print method to
use, and then tap or slide the screen to the left.
8.
Tap the type of sensor to use, and then tap or slide the screen to the left.
• If you have selected [Wristband] for media type, you can only select [Gap] or [I-Mark].
• If you have selected [koDakara] for media type, you can only select [I-Mark].
• Select something other than [None] to use the Label Waste Prevention function.
• Select something other than [None] to use RFID tags on an RFID model. If you set
[None], you cannot use RFID tags.