SATO CT4-LX - Page 179

179
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
• The changes to this setting are linked and are changed with each of the test print
settings in the [Tools] > [Test Print] menu.
[Darkness Adjust]
Fine tune the print darkness.
The setting range is from 0 to 99.
0 is the lightest and 99 is the darkest.
• The changes to this setting are linked and are changed with each of the test print
settings in the [Tools] > [Test Print] menu.
[Label Top Sensor]
Adjust position of the label top sensor.
This is not displayed if the optional dispenser unit or linerless cutter unit is installed.
Set the value '+' to correct the label top sensor in the direction opposite to the feed direction and '-' to
correct in the feed direction.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) -30 to +30 dots
305 dpi (1 dot = 0.083 mm (0.0033")) -45 to +45 dots
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
[Start Online]
Set whether to power on the product in Online mode.
• This setting is linked to [Initial Display at Start-Up] in the [Standalone] menu. By
enabling [Start Online], [Application] is enabled in [Initial Display at Start-Up]. By
disabling [Start Online], [Home Screen] is enabled in [Initial Display at Start-Up].
[Feed After Error]
Set whether to automatically feed the media when recovering from an error and changing to Online
mode.
Can be set if [Label Waste Prevention] is disabled.
Feed the media when changing to Online mode after recovering from an error.