181
• On the [Printing] > [Sensor Type] menu, [Gap] or [I-Mark] is selected.
Set a value for the media length that includes the liner.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) 1 to 20000 dots
305 dpi (1 dot = 0.083 mm (0.0033")) 1 to 18000 dots
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
• If you change to labels with a different length, do not forget to change [Registered
Label Length] too. If [Registered Label Length] is different from the actual media
length, printing may become misaligned.
• The changes to this setting are linked and are changed with the settings in the [Tools] >
[Media Startup] menu.
[Finisher Feed]
Set the media feed amount for tear-off, cut and dispense stop.
Set the media feed amount based on the print head position of 0.
The actual media feed amount is the value of [Offset] + [Finisher Feed].
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) 0 to 2040 dots
305 dpi (1 dot = 0.083 mm (0.0033")) 0 to 3060 dots
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
• A message prompting you to restart the product will appear on the Home screen if you
have made any changes. In such a case, reboot the product to apply the settings.
[Paper End]
Select the sensor for sensing the paper end.
The options are as follows:
Using I-mark
Use the I-mark sensor (reflective type) to detect the paper end.
To Next Page
Loading...
