SATO CT4-LX User Manual

[Advanced]
182
Using Gap
Use the Gap sensor (transmissive type) to detect the paper end.
[Prioritize]
For the product's settings, set whether to give priority to settings done on the product or to settings
done by commands.
The options are as follows:
Commands
Prioritize the settings through commands.
Settings
Prioritize the settings through the product.
[Reprint]
Enable or disable the reprint function.
If [Reprint] is enabled, you can tap [REPRINT] in the online screen to print the previous data again.
• The previous data is lost if the product is powered off.
[Print End Position]
Adjust the media stop position or cut position when the [Sensor Type] is set to [None]. This adjustment
also sets the blank amount from the media stop position.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) 0 to 20000 dots
305 dpi (1 dot = 0.083 mm (0.0033")) 0 to 18000 dots
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz