[Network]
204
(1) Feed direction
Horizontal
Adjust the print position of the QR code in the horizontal direction.
Set the correction value from the print reference position when facing the product as "-" to adjust
to the right side and "+" to adjust to the left side.
(1) Feed direction
The setting range is from -792 to +792 dots.
• The length of 1 dot varies depending on the print resolution of the product.
â—¦ 203 dpi : 1 dot = 0.125 mm (0.0049")
â—¦ 305 dpi : 1 dot = 0.083 mm (0.0033")
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
[Daily Checkup] (SOS users only)
Shows the current product information with a QR code. Scan the QR code with a tablet or smartphone,
and send it to the SOS cloud.
Also, the product information can be acquired via NFC and sent to the SOS cloud.
Available only if you have selected [On-Demand] in the [SOS Mode] menu.
A specialized application is required to scan the QR code or send the product information to the SOS
cloud.
If you have selected [Print] in the [Update Screen], tap [PRINT] to print the QR code.
To print the QR code, use media of more than 40 mm (1.57") in length and more than 40 mm (1.57") in
width (not including the liner).
To Next Page
Loading...
Need help?
General
