SATO CT4-LX - Page 205

205
[Advanced]
Set the advanced function for the interface.
The setting items are as follows:
[ARP Announcement]
Set the functions for ARP announcement.
The ARP announcement is useful for updating other hosts mapping of a hardware address when the
IP address or MAC address of the sender has changed.
The setting items are as follows:
[Additional]
Set the additional ARP announcement.
Enable the additional ARP announcement. The ARP is sent at 1, 2, 4, 8 and 16 seconds after the
link up/DHCP assignment.
Disable the additional ARP announcement. The ARP is only sent at 1 second after the link up/
DHCP assignment.
[Periodic]
Set the interval of the ARP announcement in the range of 0 to 600 seconds.
Initial setting is 0 seconds.
• The function is disabled if you set it to 0.
[RS-232C]
Sets the RS-232C connection.
This appears only if the optional RS-232C kit is installed.
The setting items are as follows:
[Baudrate]
Set the baudrate (bps).
The options are as follows:
• [2400]
• [4800]
• [9600]
• [19200]
• [38400]
• [57600]