211
[Threshold Value]
Set the threshold of the RSSI filter.
Appears only if you enabled [RSSI Filter].
The setting range is from -99 to -1 dBm.
[Retry Mode]
Set the mode at the time of the RFID error outbreak.
The options are as follows:
Retry
If an RFID error occurs, the product will retry writing according to the number of times of [Retries].
If the RFID errors occur consecutively, printing stops after the number of retries in [Retries] plus
one more retry occur, and the RFID error screen opens.
Tapping [RETRY] retries writing the number of times in [Retries].
Tapping [ABORT] deletes one current item.
Release
If an RFID error occurs, the next data is written, without trying to write the same data again. If the
RFID errors occur consecutively, printing stops after the number of retries in [Retries] occurs, and
the RFID error screen opens.
Tapping [RETRY] deletes one copy of the current print data, and then starts printing the next.
Example:
â—¦ If one copy each of 10 items are being printed, the current item is deleted, and the remaining
items are printed.
â—¦ If 10 copies of one item are being printed, the current print data is deleted, and the remaining
copies are printed.
Tapping [ABORT] deletes the one current item, and then starts printing the next.
Example:
â—¦ If one copy each of 10 items are being printed, the current item is deleted, and the remaining
items are printed.
â—¦ If 10 copies of one item are being printed, the current item is deleted, and then printing stops.
To Next Page
Loading...
Need help?
General
