SATO CT4-LX - Page 233

233
You can change this setting only if you have selected [Settings] in the [Prioritize] > [Pause Mode]
menu.
[1 Byte Codepage]
Select the code page to be used for one-byte characters from the list.
You can change this setting only if you have selected [Settings] in the [Prioritize] > [1 Byte Codepage]
menu.
[SDPL Measure Unit]
Set the measurement unit.
You can change this setting only if you have selected [Settings] in the [Prioritize] > [SDPL Measure
Unit] menu.
The options are as follows:
• ["] (inch)
• [Millimeter]
[Scalable Font Style]
Set the style of the scalable fonts.
You can change this setting only if you have selected [Settings] in the [Prioritize] > [Scalable Font
Style] menu.
The setting items are as follows:
[Bold]
Set whether to use bold for the scalable fonts.
[Italic]
Set whether to use italics for the scalable fonts.
[Feedback Character]
Enable or disable the <STX>a command.
You can change this setting only if you have selected [Settings] in the [Prioritize] > [Feedback
Character] menu.
[SOH Commands]
Set the SOH commands.
You can change this setting only if you have selected [Settings] in the [Prioritize] > [SOH Commands]
menu.
The setting items are as follows:
[All Commands]
Enable or disable all SOH commands. Or, make it possible to do settings for each command.
The options are as follows:
Disabled
Disable all the SOH commands.