SATO CT4-LX - Page 232

[SDPL]
232
Settings
Prioritize the settings through the product.
[SOH Commands]
Set whether to prioritize the settings through the product or through commands for the SOH command
settings.
The options are as follows:
Commands
Prioritize the settings through commands.
Settings
Prioritize the settings through the product.
[Module Selection]
Set whether to prioritize the settings through the product or through commands for the module
selection setting.
The options are as follows:
Commands
Prioritize the settings through commands.
Settings
Prioritize the settings through the product.
Others
The option selected in the [Printing] > [Advanced] > [Prioritize] menu is applied to the following settings
and shown on the screen.
• [Darkness]
• [Factory Offset]
• [Speed]
[Format Attribute]
Set the format attribute.
You can change this setting if you have selected [Settings] in the [Prioritize] > [Format Attribute] menu.
The options are as follows:
• [XOR]
• [Transparent]
• [Opaque]
• [Inverse]
[Pause Mode]
Enable or disable the pause mode.