SATO CT4-LX - Page 262

[Test Print]
262
Pitch
Set the print position in the vertical direction.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) -30 to +30 dots
305 dpi (1 dot = 0.083 mm (0.0033")) -45 to +45 dots
When you decrease the setting value, the print position moves in the feed direction.
When you increase the setting value, the print position moves opposite the feed direction.
Offset
Set the tear-off position/cut position/dispense stop position.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) -30 to +30 dots
305 dpi (1 dot = 0.083 mm (0.0033")) -45 to +45 dots
When you decrease the setting value, the stop position moves in the feed direction.
When you increase the setting value, the stop position moves opposite the feed direction.
Darkness Adjust
Fine tune the print darkness of the test print.
0 is the lightest and 99 is the darkest.
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
• The changes to the settings in this menu are linked and are changed with each of the
test print settings under the [Test Print] menu.
• The settings in [Pitch], [Offset], and [Darkness Adjust] are linked and are changed with
the settings in the [Printing] > [Advanced] > [Adjustments] menu.
[BD Address]
Print the BD address.
1. Check and set the items as listed on the [BD Address] menu.
2.
Tap to start the test print. Tap to pause printing.