SATO CT4-LX - RFID Write with Cutter Mode and Backfeed After Printing (Tag Offset = 0)

348
RFID Write with Cutter Mode and Backfeed After Printing (Tag Offset = 0)
When cutter mode with backfeed after printing is selected, the tag backfeeds after the cut and stops at
the print head position.
*1 The EPC code write <IP0> command writes the data at this inlay position. The EPC code read,
RFID read [DC2]PJ, UID/EPC/IDm print <TU>, and UID/EPC/IDm return <RU> commands acquire the
information at this inlay position.