SATO CT4-LX - RFID Write with Cutter Mode and Backfeed After Printing (Tag Offset > 0)

349
RFID Write with Cutter Mode and Backfeed After Printing (Tag Offset > 0)
When cutter mode with backfeed after printing is selected, the tag backfeeds after the cut and stops at
the print head position.
*1 Because the EPC code read, RFID read [DC2]PJ, and UID/EPC/IDm print <TU> commands
acquire the information at this inlay position, do not use them if the Tag Offset is set to other than an
initial value.
*2 The EPC code write <IP0> command writes the data at this inlay position. The EPC code read, and
UID/EPC/IDm return <RU> commands acquire the information at this inlay position.