355
RFID Write with Dispenser Mode and Backfeed After Printing (Tag Offset > 0)
When dispenser mode with backfeed after printing is selected, the tag backfeeds after dispensing
and the tag is removed, and stops at the print head position, and then the next item is analyzed and
printing is executed.
*1 Because the EPC code read, RFID read [DC2]PJ, UID/EPC/IDm print <TU>, and UID/EPC/IDm
return <RU> commands acquire the information at this inlay position, do not use them if the Tag Offset
is set to other than an initial value.
*2 The EPC code write <IP0> command writes the data at this inlay position. The EPC code read, and
UID/EPC/IDm return <RU> commands acquire the information at this inlay position.
To Next Page
Loading...
