SATO CT4-LX - Page 356

356
RFID Write with Dispenser Mode and Backfeed Before Printing (Tag Offset = 0)
When dispenser mode with backfeed before printing is selected, the tag backfeeds before printing,
and stops at the dispensing position after printing.
*1 Because the EPC code read and RFID read [DC2]PJ commands acquire the information at this
inlay position, do not use them.
*2 The EPC code write <IP0> command writes the data at this inlay position. The EPC code read,
UID/EPC/IDm print <TU>, and UID/EPC/IDm return <RU> commands acquire the information at this
inlay position.