SATO CT4-LX User Manual

Status Icon
44
Icon Description
Wi-Fi Direct is connected or the product is set to act as an access point.
Product is connected to USB host.
RFID mode is enabled.
RFID mode is enabled, but the system is defective.
Or the SATO RF Analyze (SRA) motor unit is not operating correctly.
Standard code is disabled.
The On-Demand mode of the SOS (SATO Online Services) is enabled.
The Real Time mode or the Light mode of the SOS is enabled. The product is
connected to the SOS cloud.
The Real Time mode or the Light mode of the SOS is enabled, but not connected
to the SOS cloud.
If LAN or Wi-Fi icon is grayed out, the product is not connected to the network.
If LAN or Wi-Fi icon is active, the Internet connection of the SOS cloud has a
trouble.
The product is not connected to the SOS cloud.

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz