Shimadzu GC-2014 Instruction Manual

16 Special Functions
16.6 GC Configuration
247
GC-2014
16.6.8.3 Heater Name Customization
Select “6. GC CONFIGURATION” from, the [FUNC] key screen, and then “6. PORT
NAME CUSTOMIZATION”, and finally, select “1. HEATER NAME CUSTOMIZ”, to open
the screen shown in Fig. 16.6.16.
16.6.8.4 Carrier Name Customization
Select “6. GC CONFIGURATION” from the [FUNC] key screen, and then “6. PORT
NAME CUSTOMIZATION”, and finally select “CARRIER NAME CUSTOMIZ”, to open
the screen shown in Fig. 16.6.17.
Fig. 16.6.16 Heater port name setup screen
Fig. 16.6.17 Carrier name setup screen
Only listed heated zone names
can be changed.
To change the names, refer to
“6.3.5 Changing item names”
in “6.3 Basic Key Operations”.
To change the names, refer to
“6.3.5 Changing item names”
in “6.3 Basic Key Operations”.

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)