SETTING KNOB CHANNELS
The MIDI channel and port for each control knob can be set separately. This allows each
control knob to be used to control a different device if needed.
The MIDI channel for each control knob can also be set to "track" which will change the
MIDI channel and MIDI controller number according to the currently selected track.
To set the MIDI channel for a control knob, while in CONFIG mode, press and hold
pattern step button 1, then turn the control knob you wish to set.
The channel of the knob will be displayed on the LED display. You can set the channel
from the range 1 to 16 for any of the three output ports (port 1, port 2 or USB) or “tr”. To
have the knob channel and controller change according to the selected track, rotate the
knob all the way clockwise until the LED display shows "tr".
If you just want to view the current channel assigned to a knob without changing it, while
holding pattern step button 1, press and hold the track select button corresponding to the
controller knob that you wish to view.
To Next Page
Loading...