SETTING TRACK KNOB MIDI CHANNEL/PORT
The MIDI channel and port for each control knob can be set separately per track. This
allows each control knob to be used to control a different device per track if needed. To
use track controllers, set the knob channels to “tr” in GLOBAL CONFIG mode.
To set the MIDI channel for a control knob for the selected track, while in UTILITY mode,
press and hold pattern step button 1, then turn the control knob you wish to set. The MIDI
channel of the knob will be displayed on the LED display. You can set the channel from
the range 1 to 16 or use the track defined MIDI channel.
If you just want to view the current MIDI channel assigned to a knob without changing it,
while holding pattern step button 1, press and hold the track select button corresponding
to the controller knob that you wish to view.
The current MIDI channel of the corresponding knob will be displayed on the LED display.
To Next Page
Loading...