6. While still holding the step button, set the octave of the pitch using the DOWN and
UP buttons
7. While still holding the step button, you can also set the ACCENT and SLIDE
attributes
8. While still holding the step button, a specific note velocity can be set using
controller knob 1. The current velocity of the note is displayed on the numeric
display.
9. While still holding the step button, fine tune the gate length of the note using
control knob 2. The current gate length will be displayed on the numeric display.
If slide is set, the display will show “SLD”.
10.Release the step button and repeat from step number 3 to enter new notes.
MODIFY A PATTERN
Now that you have created a pattern, you can do something dynamic with it.
•
Try the ALL ACCENT function by pressing and holding the TRANSPOSE button then
press the ACCENT button, all notes will play with accent while ACCENT button is
held."
•
Try the ALL SLIDE function by pressing and holding the TRANSPOSE button then
press the SLIDE button, all notes will be played legato while the slide button is held."
•
Release the TRANSPOSE button
•
Modify the pattern length by pressing and holding the TIME button and then
pressing a pattern step button. The new length will take effect the next time the
pattern loops."
•
Release the TIME button
CREATE SNAPSHOTS
Now we will save your pattern setup into a snapshot.
1.Select SNAPSHOT MODE by double-clicking the SNAPSHOT (down) button. The
SNAPSHOT LED will blink.
2.Record a snapshot by pressing and holding the RECORD button and then click
PATTERN STEP 1.
To Next Page
Loading...