GATE OFFSET
The gate offset effect will shorten or lengthen all gates in a pattern by up to one step.
The offset can be set from -32 to +31.
The gate offset can be used creatively to change note playback from more staccato to
more legato style. It is especially effective when you have a mix of notes that are longer
(or have slide) and short single step notes.
To set the gate offset, while in FUNCTION MODE, rotate control knob 2. The current
gate offset value will show briefly on the LED display.
DELAY OFFSET
The delay offset effect will add or subtract a delay amount to the start of all programmed
steps. This can be used to increase quantization or remove shuffle in realtime.
To set the delay offset, while in FUNCTION MODE, rotate control knob 3. The current
delay offset value will show briefly on the LED display.
TIP: The gate offset can also be used with control type patterns and
the gate signal sent by the (optional) CV output expansion board.
TIP: The gate offset can be used to change the trigger pulse size for DRUM
type patterns. Some devices require longer pulses to trigger properly
To Next Page
Loading...