Social Entropy Engine - Clear Track Settings; Clearing Track Patterns to a Specific Type

TRACKS
CLEAR TRACK SETTINGS
To clear track settings, select the “SET” clear method. Pattern data is not cleared when
clearing track settings.
When clearing track settings, the cleared values are:
"
CLEARING TRACK PATTERNS TO A SPECIFIC TYPE
To clear all 64 patterns in a track and set them to the same pattern type, select the
pattern type clear method. The type is shown on the LED display as either “DRM”,
“SYN1”, “SYN2” or “CTRL”
After confirming by clicking the SECTION button, all patterns will be erased and set to the
selected type. The track settings will be maintained.
Selected pattern/pattern chain
Reset to pattern 1, bank 1, no chain
MIDI port and channel
Reset to port 1, channel same as track number
LFO, ROLL and ARP
Reset to basic settings
CV gate mode (if applicable)
V/Oct, Positive gate
MIDI FX settings
Reset to basic settings
MIDI controller numbers
Default settings
MIDI drum note mappings
Default mapping (General MIDI)
MIDI entry, Quantize, Force to Scale
OFF, ON, All notes enabled
 USER GUIDE 31
NOTE: The track clear function is destructive and cannot be undone.