Vista Digital Mixing System
Date printed: 05.04.2005 SW V3.5 Vista 8 Differences 8-51
Targets with their respective connections can be selected by clicking on
them in the list on the general patch. Selected targets change their color to
pink to show their selection state.
Clicking on the
Map Currently Selected button maps the patches for the
selected targets (the pink-colored ones) to the ProBel connect command
specified on the left.
With
Listen to messages enabled, incoming connect messages are
mapped to the edit fields on the dialog. To select targets affected by this
connect command simply click on them in the target list of the general
patch (color is set to pink).
Make sure to always associate the same ProBel destination to the same set
of targets.
Any connection on the patch may be mapped to certain ProBel connect
commands. You are not limited just to outputs or inputs!
With
Send spontaneous messages enabled, the appropriate CON-
NECTED message is sent whenever one of the defined patch combinations
matches the same combination as when they were defined.
To Next Page
Loading...
