Vanderbilt SPC53 Series User Manual

17
Engineer programming via the browser
Configuration
228
Vanderbilt
Installation & Configuration Manual
A6V10276959
01.05.2016
Restriction
System Option
Description
PACE and PIN
If enabled, both PACE and PIN are required.
User Duress
Select one of the following Duress options to activate this
function on the system.
 PIN +1(system reserves the PIN before and after the
user PIN for duress.
 PIN + 2 (system reserves two PINs before and after
the user PIN for duress.
Duress must be enabled for individual users. See section
on Adding/Editing a User.
PIN Policy
Click on the Edit button to select options for PIN usage.
 Periodic changes required – enforces scheduled
changes to the user’s PIN. The period is defined in
the PIN Valid field of Timers. See Timers [➙ 230].
 Warn if changes required – generates a user alert if
the user’s PIN is about to expire, or has expired. The
warning period is defined in the PIN Warning field of
Timers. See Timers [➙ 230].
 User selects the last digit – enables the user to select
the last digit of their pin. The preceding digits are
automatically generated by the system.
 User selects the 2 digits - enables the user to select
the last two digits of their PIN. The preceding digits
are automatically generated by the system.
 Limit Changes – limits the number of changes
possible within a valid PIN period. This value is
defined in the PIN Changes Limit field of Timers. See
Timers [➙ 230]
 Secure PIN - If enabled the PIN will be automatically
generated by the panel.
Door
Reset Cards
If enabled, access cards passback state will be reset
every day at midnight.
Ignore site code
If enabled, the access system will ignore site codes. By
ignoring the site code, you only add the card number and
increase the card users on the system from 100 to 2,500.
Card Formats
Click on the Edit button to select the card formats that will
be allowed on this panel.
Refer to the Appendix in the SPC Installation &
Configuration Guide for details of currently supported
card readers and card formats.
Note: Selecting Wiegand enables all Wiegand card
formats.
Web and
SPC Pro
Only
Door Mode Set
Select the required user identification to unlock door
when area is set. Options are Default, Card and PIN,
Card Or PIN.
Web and
SPC Pro
Only
Door Mode Unset
Select the required user identification to unlock door
when area is unset. Options are Default, Card and PIN,
Card Or PIN.
Engineer
Engineer Restore
(Impact only if Region "UK" is chosen): If this option is
enabled, then the engineer has to restore the confirmed
alarms. This option works together with the function
"Confirmation".
Engineer Exit
If enabled, the engineer is allowed to leave Full Engineer
mode with alerts active.
!

Vanderbilt SPC53 Series Specifications

General

Brand	Vanderbilt
Model	SPC53 Series
Category	Power Supply
Language	English