Engineer programming via the browser
Configuring Communications
Installation & Configuration Manual
Check any of the following boxes if you want to initiate a remote call to an EDP
Receiver to notify it of the particular event.
System alarms are restored.
Alarms confirmed by multiple zones
Alarm Abort events. Alarms are aborted after a valid user code is entered
via the keypad after a confirmed or unconfirmed alarm,
Faults and tampers are activated.
Fault or tamper alarms are restored.
Report all zone input state changes.
Unscheduled setting and unsetting of the system.
Inhibit and isolate operations are performed on the system.
Door events are activated. Only works with SIA protocol.
All other types of events are detected on the system.
Non supported SIA codes used with SPC COM XT including Camera
Online/Offline events.
To Next Page
Loading...