Vanderbilt SPC53 Series User Manual

Engineer programming via the browser
17
Configuring Communications
299
Vanderbilt
Installation & Configuration Manual
A6V10276959
01.05.2016
Dial-up Interval 2*
Enter number of minutes between dial-up test calls when network
link is down.
Network Address*
Enter the IP address of the receiver. This is only required if the
connection to the EDP receiver is being made over the Ethernet
interface. If using one of the on-board modems then leave this field
blank.
Phone Number*
Enter the first phone number that the modem(s) will dial to contact
the receiver.
Phone Number 2*
Enter a second phone number that the modem(s) will dial in the
event that the first number dialled did not result in a call being
successfully established.
Events
Primary Receiver
Check this box to indicate that this is the primary receiver. If
unchecked, this is a backup receiver.
Re-queue Events
Check this box if events that failed to report are to be re-queued for
transmission
Verification
Check this box if Audio/Video verification is to be sent to this
receiver.
Event Filter
Click this button to edit the filter events that will trigger an EDP call.
Refer to Editing Events Filter Settings [➙ 299].
* EDP dial-up over PSTN is not supported in this release.
See also
 Configuring SMS [➙ 190]
Editing Event Filter Settings
1. Select Communications > Reporting > EDP > Edit > Filter
 The following window will be displayed.
2. Configure the fields as described in the table below.
17.10.3.2.3

Vanderbilt SPC53 Series Specifications

General

Brand	Vanderbilt
Model	SPC53 Series
Category	Power Supply
Language	English