Xerox Phaser 790

10/00
4-27
Phaser 790/DocuColor 2006
REP 5.5
Repairs and Adjustments
Initial Issue
5. Remove the Lower Chute. (Figure 2)
Figure 2 Removing the Lower Chute
6. Remove the Nudger Roll Assembly parts. (Figure 3)
Figure 3 Removing Nudger Roll Retaining Parts
1
Open the Feeder
Cover
2
Loosen the screw
3
Remove the Lower Chute by
moving the chute in the direction
indicated
1
Remove the screw
retaining the Nudger
Home Sensor and
remove the sensor
2
Remove the E-Clip.
Sensor Actuator, Gear,
and Bearing
3
Remove the E-Clip,
Pulley Belt, Pulley
and Bearing